日本油研方向控制閥造型參數，原裝YUKEN控制閥
如果您對該產品感興趣的話,可以
產品名稱: 日本油研方向控制閥造型參數，原裝YUKEN控制閥
產品型號: DSG-01-3C2-A240-N1-50
產品展商: YUKEN-油研
產品文檔: 無相關文檔
簡單介紹
日本油研方向控制閥造型參數，原裝YUKEN控制閥
很*的完成。
一定要在下列規定的條件下使用液壓油：surge pressure in it. Be sure to keep the end of the tank line
pipe below the oil level. As the solenoThese DSG-005 series solenoid operated directional valves are the products
newly developed as a "Mini-series". Compared with DSG-01 series,
the valves are much more compactly manufactured but enjoy a maximum
opera
日本油研方向控制閥造型參數，原裝Y
日本油研方向控制閥造型參數，原裝YUKEN控制閥
的詳細介紹
日本油研方向控制閥造型參數，原裝YUKEN控制閥
上海乾拓貿易有限公司
企業QQ：
電話；021-69001039
手機；17321017802（微信）
郵箱；[email protected]
聯系人；楊婷玉
地址：上海市嘉定區江橋嘉涌路99弄6號713室
mounting posture.
Solenoid Energisation
When energising one solenoid, be sure to de-energise
another solenoid beforehand.
Tank Port
Do not connect the tank port to any pipe line having a
有一個很*的完成。
一定要在下列規定的條件下使用液壓油：surge pressure in it. Be sure to keep the end of the tank line
pipe below the oil level. As the solenoThese DSG-005 series solenoid operated directional valves are the products
newly developed as a "Mini-series". Compared with DSG-01 series,
the valves are much more compactly manufactured but enjoy a maximum
operating pressure of 25 MPa (3630 PSI) and a maximum flow rate of
10 L/min (2.6 U.S.GPM), while contributing further to a space saving
requirement. Moreover, using
以使用下表中列出的液壓油類型。
安裝螺栓
包括下表中的四個內六角頭螺栓Mounting Posture
For any model, there are no restrictions regarding theids are of wet type。
子板可用。 從上表中**子板號。 當不使用子板時，配套表面應該
粘度：20-200mm 2 / s（100-930SUU），溫度：-15?+ 60℃（5?140°F）。
**的粘度和油溫
必須謹慎，以保持對可能導致的液壓油污染的控制
故障和縮短閥門的使用壽命。 請保持學位
日本油研方向控制閥造型參數，原裝YUKEN控制閥
